Effective with the November 2020 Letting 2021 Standard Specifications 506 Steel Bridges 506.1 Description (1) This section describes fabricating, furnishing, casting, machining or preparing otherwise, delivering, and erecting the steel and miscellaneous metals required for steel bridges, or
ASTM-A709 Standard Specification for Structural Steel Grade 50W [345W], or HPS 50W [HPS 345W] shall not be substituted for Grades 36 , 50  or 50S [345S] without agreement between the purchaser and the supplier. 1.3 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized.
Carbon and Low-alloy High-strength Steel provide greater environmental corrosion resistance and are stronger than convention carbon steel,also very ductile, highly formable and easy to weld.Carbon and Low-alloy High-strength Steel steels are not typically made to meet a certain chemical composition, instead they are known to meet specific mechanical properties.
OREGONS BIOGRAPHY SECOND ASTM A1010 BRIDGE o Yield and tensile strength of A709 Grade HPS 50W. º Young's Modulus of 2900 ksi. º The Oregon Department of Transportations weldability study was limited to 1-inch-thick plate but the Project Special Provisions required weld procedure prequalification of full penetration weld for ½ and 1¾ plate thicknesses. This requirement
carbon and low alloy steel plate - BBN STEELCarbon and low alloy steel plate is a steel with carbon content from about 0.05% up to 2.1% by weight. The term "carbon steel" may also be used in reference to steel which is not stainless steel; in this use carbon steel may include alloy steels.
SSAB offers the following five grades of A709; 36, 50, 50W, HPS 50W and HPS 70W. The three weather grades of 50W, HPS 50W, and HPS 70W have an ASTM G101 enhanced . ASTM A709 Grade HPS 100W Steel Sheet/Plate Suppliers, ASTM A709 Grade HPS 100W is either available as exstock or directly shipped from the mill to our customers across the globe.ASTM A709 - SSABThe ASTM A709 is the Standard Specification for Structural Steel for Bridges and encompasses carbon, high-strength low-alloy, and quenched and tempered alloy steels used as structural plates in the construction of bridges. SSAB offers the following five grades of A709; 36, 50, 50W, HPS 50W and HPS 70W. The three weather grades of 50W, HPS 50W, and HPS 70W have an ASTM G101 enhanced